Do Stud Finders Work Through Vinyl Siding

That s why a stud finder is so crucial.

Do stud finders work through vinyl siding.

This would be pretty easy. For vinyl siding use a vinyl siding removal tool to unsnap the seal between two pieces of siding allowing you to see the nail heads. The better way is to locate the edges of the osb sheathing. You might be able to locate the studs on the inside of the wall using a stud finder and then using the center of a window as a reference point measure how far over the studs is.

I was wondering. Place the stud finder at the edge of the exterior siding. The heat transfer through the studs makes them show up pretty well in our climate. Further the approximate area of where i need to mount this bracket includes an area of the wall that has a bunch of electrical wiring running through it romex through holes in the studs.

I have a situation where i need to mount a fairly stout bracket to the exterior of the building and i need to find one of those studs to do so. Our experience shows that most battery operated types work fairly well to some extent. For solid cladding such as stucco or brick your best bet is to locate the studs inside the house and then transfer the measurements to the exterior wall. Walk very slowly along the exterior siding while holding the stud finder.

A little light will go off or the finder will make a beeping noise when it finds a. This is not always the case depending on the installer. The edges must be nailed into a stud. In theory the siding should be nailed at the studs.

The best way to find a stud while working on on the outside whether brick siding or stone is to use an electronic stud finder. Some finders provide basic detection capabilities that are good for just walls. Use a stud finder to locate a stud on any wall that is drywalled in your shower room by placing the stud finder up to the wall turning it on and moving it slowly until it beeps. Some of this is a function of you get what you pay for since many low cost stud finders do not have the penetrating power to accurately get though the wall materials to find the studs.

Then go on the outside hold your tape measure in. If that s true and i wanted to hit a stud close to dead center i d probably make myself about a 6 long 3 32 diameter drill bit locate a stud from inside and bore a hole from. All stud finders do the same basic thing. Detect where support areas like studs and joists are along the wall.

Remove the section of siding at the elevation you plan on mounting the awning at. Measure 16 and mark additional stud locations.