Unplug the dryer to disconnect electrical power.
Dryer thermal cutoff fuse keeps blowing.
I tested the dryer and it heated right up.
Same thing happened to my furnace in my travel trai.
Whirlpool kenmore electric dryer keeps blowing thermal fuse.
The dryer was not heating so i performed the test number 3 for heating problems in the tech sheet.
When the fuse blows the dryer won t get hot but when the.
I attempted to dry another load of clothes and it didn.
I have a whirlpool electric dryer that keeps blowing the thermal fuse at the vent outlet.
If you notice that the drum spins but there s no heat produced the thermal cutoff switch is probably blown.
It also helps monitor the amount of heat being produced by the dryer.
My samsung dryer kept blowing the thermal fuse.
The fuse controls the dryer s heating element whereas the cutoff controls the motor.
Get shopping advice from experts friends and the community.
What it finally turned out to be was the samsung dc96 00882c dryer idler pulley.
A groove opening somehow got worn into it.
Use electrical tape to properly insulate the connection and avoid contact of bare wire contacts with the dryer cabinet.
I checked and have no obstructions in the short line outside 5 duct run is all i have and have replaced the cycling thermostat that should prevent the temperature from getting high enough to fail the thermal fuse.
With the fuse out the element still gets heated but the dryer doesn t spin.
I replaced the fuse and the dryer worked for a good 30 mins and then it stopped.
I found the problem to be the thermal cut off and replaced that part.
The thermal cutoff isn t the same as a thermal fuse.
I had a friend with a non working clothes dryer give me a call turns out it was just a bad thermal fuse.
Heating element turn read more.
I have a kenmore elite he4 electric dryer model number 11085872400.
Thermal cutoff heater assembly fuse keeps tripping.
The thermal cutoff is located on the heater assembly and it controls the temperature of the dryer.
The thermal fuse on my inglis maytag dryer keeps blowing.
Before replacing the thermal fuse again try these steps.
Temporarily tape the two wires that go to the thermal fuse together to essentially bypass or jump the thermal fuse.
